If the downloaded file is detected as malware, set an exception in your anti-virus software to allow the application to run.
The setting method differs for each software, so check with the security software manufacturer or your security administrator.
Settings for controller DCC0241X can be easily set from PCs.
Setting data can be saved and loaded. You can also retrieve the settings from the controller.
Operates on Windows 7, Windows 10
Install Microsoft .NET Framework4 to operate with Windows7
Click on the download icon below.
The files are compressed "ZIP" files. Extract the files to use.
Use the "DCC0241X Settings application-vXXX.exe" inside the extracted folder.
For operation details, please read the "instruction manual"
By using with "delvo" Brushless Type C Series, "output torque (converted value)", "screw fastening time", "OK(Pass)/NG(Fail) judgment" and "fastening data log" can be checked.
Connect the Screw Fastening Monitor between the screwdriver and controller to use.
* This software is a simplified version. Function expansion is not supported.
Operates on Windows 7, Windows 10
Install Microsoft .NET Framework4 to operate with Windows7
Click on the download icon below.
The files are compressed "ZIP" files. Extract the files to use.
Use the " screw fastening monitor.exe" inside the extracted folder.
For operation details, please read the "operation manual"
Data-Uploading Program enables exporting of data measured by Torque Checker to spreadsheet software such as Microsoft Excel, etc.
| Software | Applicable Models | Operating System |
|---|---|---|
| EDSS-2 | DLT1173、DLT1673、DLT1973 | From Windows 95 to Windows 10 |
| EDSS-3 | DLT1173A、DLT1673A、DLT1973A | From Windows 98 to Windows 10 |
| EDSS-4 | DLT1173A、DLT1673A、DLT1973A | Excel Macro file. Operates on PCs with Micorsoft Excel installed. |
* Installation of a USB driver is required beforehand when using EDSS-3 and EDSS-4.
Download the latest version of "VCP Drivers" from FTDI Chips Virtual COM Port Drivers http://www.ftdichip.com/Drivers/VCP.htm and make the setting of the driver.
Click on the download icon below.
The files are compressed "ZIP" files. Extract the files to use.
Please be sure to read the "Readme" file included in the extracted folder before using the software.
For EDSS-2 and EDSS-3, installation starts by executing the "SETUP.EXE" in the created folder.
Once the software is installed, select EDSS-2 or EDSS-3 from the start menu of Windows.
For EDSS-4, execute the "EDSS-4.xlsm" in the created folder.
"URCap" is a software which can be used when mounting "delvo" Brushless Type C series, model DLV45C on collaborative robots made by Universal Robots.
Settings of DLV45C can be operated with teach pendant by using this software.
When connected to robots with I/O cable, 5-bit input signals are no longer required, and the channel switching of DLV45C can be easily done by just tapping the icon on the teach pendant.
Software Version Required : Polyscope version 5.9.1
Click on the download icon below.
The files are compressed "ZIP" files. Extract the files to use.
Use the "nittokohkiscrewdriver-1.3.0.urcap" inside the extacted folder.
