| Model | DTM10 | DTM45 | |
|---|---|---|---|
| Connectable models | Electric screwdriver | DLV04C10L-A# DLV10C10L-A# #: X, Y, Z |
DLV45C12L-A# DLV45C12P-A# #: X, Y, Z |
| Controller | DCC0101X-AZ | DCC0241X-AZ | |
| Transmission data | Operation channel / Converted current value* | ||
| Screw fastening time | Screw fastening time / Rotation signal | ||
| Communication method | RS-232C | ||
| *Converted current value: Motor current value at torque-up converted to a value between 0 to 4095 | |||
Preparation 1) Check COM port, change communication setting
Preparation 2) Measure torque conversion factor
Preparation 3) Set judgment values
1) Measure with Torque Checker and compare the difference between the software and Torque Checker.
*You can actually fasten screws on your actual products to check.
2) Example of OK (Pass) / NG (Fail) judgment is shown by movie.
- When both torque value and fastening time is OK (Pass).
- When torque value (converted value) is NG (Fail), fastening time is OK (Pass).
